|Property Serv LLC||
Tip of the Week
Interior prehung doors. Here are a few tips when installing these. First, make sure the door jambs have equal distance around them in the rough opening. From here I think it's personal preference. After the door is leveled and squared up and the shims are installed, I take out the middle screws of the hinges and replace them with 3" screws into the studs. Now on the latch side you will obviously be drilling into the jamb. I use a countersink with a center drill bit to make my pilot holes, hint: make sure you install screws where the shims are. I may use 2 1/2" or 3" screws on this side, it depends on how much space is between the jamb and the stud. Some people use nails, I like screws, personal preference. Fill in the holes using wood filler, sand smooth and paint. The key with this is making sure the door closes and latches without rubbing. Open and close the door as many times as needed to make sure this is achieved. Some older homes have settled or come out of square and will pose a challenge when using prehung doors. Also remember that the standard sizes from back in the day aren't the same as they are now. Now things are "nominal", that means things are an 1/8" to a 1/4 inch shorter depending on the manufacturer. This is also true with door slabs, bifold doors, ect. Measure the product you plan on using to ensure things will go as planned.
Craig Jones, owner of Property Serv LLC. My goal is to better educate the homeowner and to make Richmond a better place to live.