Sanding drywall: When sanding drywall seams, it's good to follow the seam instead of going against it. It's better to go in circles, this way everything is blended and faded instead of getting that "path" from over sanding. Use a scrap piece of lumber or something hard and flat to put under your sand paper, this will keep things uniform. Using your hand can result in high and low spots which ultimately leads to more work. Also if you need the seams to dry quickly, try mixing your own "mud" instead of using the premix. The powedered mix comes in drying times of 20 minute, 45 minute, and 90 minute. The work times aren't very long with these so keep moving!
Interior prehung doors. Here are a few tips when installing these. First, make sure the door jambs have equal distance around them in the rough opening. From here I think it's personal preference. After the door is leveled and squared up and the shims are installed, I take out the middle screws of the hinges and replace them with 3" screws into the studs. Now on the latch side you will obviously be drilling into the jamb. I use a countersink with a center drill bit to make my pilot holes, hint: make sure you install screws where the shims are. I may use 2 1/2" or 3" screws on this side, it depends on how much space is between the jamb and the stud. Some people use nails, I like screws, personal preference. Fill in the holes using wood filler, sand smooth and paint. The key with this is making sure the door closes and latches without rubbing. Open and close the door as many times as needed to make sure this is achieved. Some older homes have settled or come out of square and will pose a challenge when using prehung doors. Also remember that the standard sizes from back in the day aren't the same as they are now. Now things are "nominal", that means things are an 1/8" to a 1/4 inch shorter depending on the manufacturer. This is also true with door slabs, bifold doors, ect. Measure the product you plan on using to ensure things will go as planned.
I started a new closet project late last week in a master bedroom that did not offer such a thing. Currently the framing is almost complete and two of the three ceiling boxes are up. This design will feature a 70" main closet with two coat closets, one at each end. With the ceiling in the room at nearly nine feet, this will provide plenty of storage and will be a great feature in the room.
Another issue that will be addressed is lighting. Don't you hate it when you have a great closet, but can't see in it? I'm adding lights down low so that shoes or other items can be seen.
This project is part of a bigger renovation involving this whole master. New drywall, electrical, shelving, and paint. Stay tuned, pics coming soon.